| |
With
industry safety, stability and ease of use in mind, our
universal board continues to impress it's users. The
board takes the place of the control circuits in the
knives, safety beams and no repeat cut. In keeping with
safety regulations, it is designed with a .03 second
cutting solution. Both cutting buttons must be press
within .03 seconds of each other to make the cut. Note:
All the knifes current safety network is still used.
Designed, so that all parts
are available and changeable by the operator, with an
led for each relay. If a relay is not lit, you know
which is not working. All the operator need do, is plug
a new relay in place. This results in little or no
downtime. Cut and clamp takes the place of 10 normal
boards in just one application, making installation a
breeze when installing an after
market computer. With only 10 wires to hook up,
and a few changes to switches, your in business! Making
it simpler and easier for your operator to work with
NEW features have been added
to insure the safety of the operators. |
-
Double switch cut control.
-
Minimum of .03 seconds between cut switch and activation.
-
Safety
beams.
-
Anti-cut repeat.
-
Cut enable included for cutters and computer control.
-
Safety circuit is 24VDC - Transformer supplied
if needed.
-
Safety pin, clutch and clamp voltages of cutter, 2 different
voltages may be used - (ex. safety pin is 110 VAC).
-
All existing switches ( ex. cam switches, solenoids) are
used.
-
Fuses
control each function and LED's indicating each relay
function, for ease of troubleshooting.
-
All
parts plug in and are available at local electronic
suppliers.
|
|
|
|